Orginally designed for Formula Renault this kit is now used on single seaters, GT cars and historic F1, now being imitated by our competitors !
 
The aluminum mounting block is machined from solid. It has a recessed 5mm drilling in the centre for mounting with a bolt. The sensor thread pitch is M10 x 1
 
Measuring brake pressure is vital for any race car data logging system. Analysis of brake pressure will show how the brakes are set up front to rear, when you are braking and mostly importantly, how you are braking and trailing into the corner.
 
The kit supplied is complete less sensors.  The kit is :
Anodised aluminum mounting manifold
dowty washers x 2 ( for sensors )
bleed nipples
fittings x 2  to take -3 brake lines
copper washers x 2